Walls must be flat and level before reinforced fiberglass panels are installed.
Reinforced are used along the walls of hospitals, kitchens and bathrooms. These panels make it easy to wipe down the walls. The ease in cleaning reinforced fiberglass panels helps keep rooms sanitary and clean. Installing reinforced fiberglass panels is not difficult, and an average room can be fitted with the paneling in just a few hours. Learning to install the paneling will help you know get started on this project.
Instructions
1. Set the reinforced fiberglass panels in the room where they will be installed. Leave the panels in the room for two to three days so they can adjust to the climate in the room.
2. Prepare the walls for the panels. Check to see if there are any uneven areas on the wall. Level out uneven areas with a small amount of drywall mud and a trowel. Spread the mud over the walls until they are flat. Let the mud dry overnight.
3. Set the reinforced fiberglass paneling on the wall. Check the size of the paneling. Trim the paneling to size with a circular saw fitted with a carbide blade.
4. Apply paneling adhesive to the back of the cut panel with a notched trowel. Spread the adhesive over the entire surface of the back of the wall in a crosshatch pattern.
5. Set the reinforced fiberglass panel in place on the wall. Use a laminate roller to roll over the surface of the panels. The roller will ensure that the adhesive sticks to both the wall and the panel. Rolling over the paneling will also ensure that you eliminate any air bubbles from behind the panels.
6. Continue installing the reinforced panels. Leave approximately 1/8 space between each of the panels to allow for expansion and contraction.
7. Install divider and cap molding on the top edge of the panels. Cut the moldings to size on a miter saw and apply silicone caulk along the back of each molding before setting them in place at the top and sides of the panels.
Tags: fiberglass panels, reinforced fiberglass panels, reinforced fiberglass, ,