Tin ceilings were commonly installed in homes that were built from the late 1800s to about the 1930s. Using tin was cheaper than plaster or wood paneling during this time. This type of ceiling was also installed to prevent plaster from falling off the ceiling, a common problem that still occurs today. You can repair an existing tin ceiling by first determining the condition of the ceiling and the tin paneling.
Instructions
1. Search the entire ceiling to see if there are any small holes or areas of damage that will need to be repaired or replaced. Small holes in tin ceiling tiles can indicate rust spots.
2. Remove loose paint from the tin ceiling panels using a wire brush or a wire brush attachment for a power drill. Lightly apply pressure to the tiles so just the loose paint will come off the tile. You do not want to scratch or ruin the pattern of the tile.
3. Remove that will prevent paint from adhering to the tin panel. Lightly sand the rust spots using sandpaper or steel wool.
4. Apply silicone caulk to seal any small holes in the tile. Run your finger over the caulk to smooth is out over the hole.
5. Remove damaged tin panels by pulling out the nails securing the panels to the ceiling, using a pry bar or a tack puller.
6. Apply a coat of primer to the new tin panel with a paint brush or roller and let it dry for about an hour.
7. Attach the new tin ceiling panel to the finishing nails.
8. Apply a new coat of paint to the ceiling tile with a paint brush or roller to complete the project.
Tags: rust spots, Apply coat, , ceiling using, loose paint, paint brush