A Hunter ceiling fan adds beauty to any room. The fan helps cool a room in the summer and keeps a room warmer in the winter. This versatile fan significantly improves the efficiency of your heating and cooling devices and will reduce your energy bills. When installing a Hunter ceiling fan, follow the manufacturer's directions carefully. After installation, your Hunter ceiling fan may require a few adjustments to ensure maximum operation.
Instructions
Problem: Fan Does Not Move
1. Turn the house power on. Check the house fuse, and replace if necessary or reset the circuit breaker.
2. Loosen the fan canopy, and check all connections. Refer to the fan wiring section of the installation guide.
3. Inspect the plug connection in the switch housing.
4. Push motor reversing switch firmly up or down. Make sure the switch is engaged.
5. Remove any remaining shipping packaging.
Problem: Fan Operates Noisily
6. Check the blade bracket screws, and tighten if needed.
7. Check the blade screws, and tighten if needed.
8. Check the blades, and if any are cracked, replace all of them.
9. Ensure the light fixture glass is secure, and tighten the screws if needed.
10. Check screws in the switch housing mounting plate, upper switch housing and lower switch housing, and tighten if needed.
Problem: Fan Wobbles
11. Tighten the blade screws.
12. Install a balancing kit if the fan wobbles too much during operation. A balancing kit is included in the fan packaging. Follow separate instructions enclosed in the balancing kit.
13. Turn off the house power, and check that the fan hanger ball is seated properly in the canopy.
Problem: Using the Remote, None of the Fan Functions Will Work
14. Ensure that wall switch is turned on.
15. Make sure that the transmitter and receiver are set to the same jumper switch setting.
16. Replace the battery in the remote.
Problem: Using Remote, Fan Functions Work Inconsistently
17.Turn off wall switch for 5 to 10 seconds. Turn it back on.
18. Check that the remote battery is installed properly.
19. Change both transmitter and receiver jumper switch settings. The code should be the same for both the transmitter and receiver.
Tags: switch housing, , needed Check, tighten needed, transmitter receiver