Install glass light shades to cover bare bulbs.
An exposed light bulb isn't the most stylish light fixture style available. Instead of leaving an exposed light bulb in the room, choose a pretty glass
Instructions
1. Loosen the small screws around the lip of the light fixture base that help hold the glass light shade in place. Loosening the screws allows room for the glass light cover to slide into the lip. The screws are small, so adjusting them with your fingers is easy.
2. Hold the glass light shade up towards the light fixture. It should be obvious which side of the
3. Slide your glass light shade up into the appropriate area on your light fixture base.
4. Tighten the small screws surrounding the lip where you will conduct your glass shade installation. Turn each screw to the right with your fingers until you feel a bit of pressure. Try not to tighten the screws too much or you could break the glass light shade.
5. Wiggle the glass light cover with the hand holding the shade to make sure it's firmly in place. Let go of the shade, but keep your hand close to make sure it stays put.
6. Turn on the light switch to test the appearance of your new glass