Install Armstrong 12X12 Ceiling Tiles
Ceiling tiles provide an easy and economical way for improving the look of a room, brightening an existing ceiling, or finishing off a room. Installation is easy and quick and may be done by as few as two people. Armstrong ceiling tiles are available directly from Armstrong or from most home improvement stores. 12X12 ceiling tiles are installed using hanging frames and wall mounted tracks.
Instructions
1. Determine the square footage of the room by measuring two adjoining walls and multiplying them together. Once you have this measurement you will know the number of tiles needed to complete the ceiling.
2. Measure down the wall to a point that is clear of anything hanging from the ceiling like ducting or pipes. Make at least two measurement marks on each wall and string a chalk line between the points to create a straight guideline around each wall.
3. Note the direction the ceiling joists travel and begin laying the first set of track strips so they are perpendicular to the first wall. Use a stud sensor to locate the studs in the wall and place at least two 1 1/2-inch nails into each strip. Butt the ends of strips together, keeping the position straight on the chalk line across the whole wall. Cut the final strip to fit snug to the wall corner.
4. Use a level to verify that the strips are straight and even, and continue nailing strips around the rest of the room until complete. As long as you have checked for level periodically and followed the chalk line the final ends will join up perfectly.
5. Begin installing the cross members by snapping one end into any track at the first 12-inch indicator marked on the track. These are pre-marked to make it easier to install the track. Mount a joist hanger in the cross member also at the marked 12-inch mark and begin attaching to the underside of the subfloor or to a ceiling joist. Continue this until you have reached the other side of the room.
6. Check for level, and adjust any hangers that need raised or lowered to achieve level by turning the small screw on the hanger to raise and lower the bolt. Repeat this process of hanging cross members across the entire first row of track. When you reach the end, if there is not room for a full tile, stop and note the distance needed for cutting partial tiles.
7. Thread the second set of cross members from either of the adjoining walls, running them over the top of the first pieces to form the checkerboard pattern frame to hold the panels. Again, align these with the pre-marked 12-inch notations on the tracks. Note the size of any partial panels necessary once the frame is complete.
8. Begin placing the 12X12 tiles into the frame. Lift them vertically up through the frame at the diagonal corners, turn it horizontally, and ease it down into the opening so it is flush with the frame. Continue doing this for all full tiles.
9. Carefully measure each partial tile hole and prepare to cut the ceiling tile by laying it flush on a smooth level surface like a concrete floor or large workbench. Place a straightedge over the tile at the cut mark and draw a sharp utility knife across the tile repeatedly until you have cut through. Place the tile and check for proper fit.
Tags: chalk line, cross members, adjoining walls, ceiling tiles, each wall