Sunday, March 9, 2014

Change A Tail Light On A Ford Explorer

Ford's Explorer SUV has been around since 1991. Despite various changes over the years, the rear lighting setup has remained basically the same. The procedure to replace tail lights on a Ford Explorer is almost identical for 1995 to 2001 models, as well as 2002 to 2009 models. Check the operation of your lights once a month; promptly replace any exterior bulbs that are burned out.


Instructions


1. Turn the headlamp control switch off and set the parking brake. This keeps you safe while you are working behind the Explorer.


2. Open the rear gate with the handle. Remove the two screws from the tail light hub. On the 1995 to 2001 Explorer the screws are on top. On 2002 to 2009 models the screws are on the edge.


3. Pull the tail light hub out. Access the tail light bulb from behind and turn it counterclockwise about one-quarter of a turn. This releases it from the hub. Gently pull the bulb out of the socket without turning it.


4. Push the new bulb into the socket while wearing gloves. If you don't have gloves, cover the bulb's glass with a paper towel. This prevents you from touching the glass, which can cause problems.


5. Push the socket with the new bulb back into the tail light hub. Turn it one-quarter turn clockwise. Push the tail light hub back into place. Pay attention to the retaining pin on the rear. It should insert into the mounting hole for perfect fitting. Replace the screws and close the gate to finish.


Tips Warnings


Don't use bulbs other than the 3157K.


Don't touch the glass. If you do, you may damage the bulb.








Related Posts:




  • Change A Tail Light Bulb On Your Ford Explorer

    Change your tail light bulbs as soon as they die.When the bulb in your tail light goes out, replace it as soon as possible. Fortunately, changing the bulb is no harder than it is on any other Ford...


  • Change The Front Turn Signal Bulb In A 2008 Ford Explorer

    The 2008 Ford Explorer is equipped with two headlight units. The headlight units consist of three bulbs, one for the headlight, the turn signal and the marker light. When the turn signal burns out...


  • Replace A Brake Or Tail Light In A Ford Explorer Expedition Excursion

    This is a 2006 Expedition, but it will give you a basic gist.Changing a tail light or even replacing a broken lens on the rear of your Ford car or SUV is very simple, and you only need a cross tip...