To spruce up the look of a room, consider installing faux ceiling beams. Since faux beams do not provide any structural support, you can make them out of wooden boxes, plastic foam, polyurethane or resin. Lightweight faux beams make overhead installation easier, and you can apply almost any paint or finish you desire to achieve your favorite effect, such as rough-hewn wood or shiny varnish. You can add architectural interest to your interior decor in just a day or two.
Instructions
1. Calculate the total length of beam material you will need. Measure the ceiling's width and multiply by the number of beams you want in the room. This equals the total length of material you will need. Add 5 to 10 percent, to have enough extra in case of any mistakes.
2. Make outlines with painter's tape on the ceiling where you want to install the beams. Use the stud finder to locate the studs within these outlines and mark them with a pencil on the painters' tape outside of where the will be placed. This way, you can later see where the mounting blocks are when you cover them with the faux beam material.
3. Begin with the board for the bottom of the beam, the side that will face the floor. Attach two boards of equal width along the long edges of the bottom plank, to form the sides of the faux beam. It is a good idea to use narrower boards for the sides of your faux beams. This makes them lighter and easier to mount. Since the ends of the beams will touch the wall, it will not be necessary to close them. Paint or finish the beams as you like.
4. Cut mounting blocks from two-inch by two-inch lumber. Measure the inner width of the faux beams and cut the blocks to fit. For example, if the inside of your faux beam is four inches, each mounting block will be four inches wide, two inches high, and two inches thick. You will need one mounting block for every stud you marked on the painters tape.
5. Attach a mounting block at each stud you marked on the tape. It will span the width of the faux beam inside. Use heavy-duty screws to ensure they are securely attached to the studs above the ceiling. Position the blocks carefully in a straight line or you will not be able to mount the beams on them.
6. Try and place the beams over the mounting blocks to make sure they fit correctly. If they do not fit, reposition the mounting blocks for proper fit. Then apply construction adhesive to the edges of the beam that will come in contact with the ceiling. Also apply glue to the sides of each mounting block where it will contact the beam inside. Set the glued beam over the wooden blocks, tightly against the ceiling.
7. Screw through the sides of the beam into each of the , countersinking them slightly. Wipe away any excess glue with a damp cloth.
8. Fill the countersinks with matching wood filler or putty. Paint if needed.
Tags: faux beams, mounting blocks, faux beam, mounting block, , will need